CONSTRUCTION OF A MICROCONTROLLER BASED GATE

  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0198
  • Access Fee: ₦5,000 ($14)
  • Pages: 58 Pages
  • Format: Microsoft Word
  • Views: 909
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853
ABSTRACT
Microcontroller based automate controller is a project design of a system that is used in operating a gate automatically. The system opens the gate automatically when a human being or car is about to enter a compound or exit a compound. The system works by sensing the light rays from the head lamp of the vehicle. The light ray is sensed and signal is used in operating the gate. Different blocks of circuit are put together to ensure that the system works perfectly as desired. The blocks include; the power supply unit, the control unit, the sensor unit, and drive unit. The power supply unit powers on the entire system, it supplies appropriate dc signal to where it is needed. The supply unit is made up of a 12volts step down transformer, a bridge rectifier circuit, a filter capacitor and a voltage regulator IC. The control unit receives signal from the sensor section to control the remaining part of the system. The control section is the logical part of the system and decides the state of the entire system depending on the signal from the sensor unit. The control section carries its operation with use of a microcontroller ATMEL89S52. The sensor unit receives signals from the headlamp of the vehicle or the human being and sends signals to indicate that a human being or car is present. This is achieved with the use a light dependent resistors. The drive unit is a DC motor which carries the gate to a specific direction as indicated by the microcontroller.

TABLE OF CONTENTS

Title page - - - - - - - - - - - i
Approval page - - - - - - - - - -ii
Dedication - - - - - - - - - - -iii
Acknowledgement - - - - - - - -iv
Abstract - - - - - - - - - - - -v
Table of contents - - - - - - - - -vi
List of figures - - - - - - - - - - -x
List of tables - - - - - - - - - - -xii

CHAPTER ONE
1.0 INTRODUCTION - - - - - - - - -1
1.1 BACKGROUND OF THE PROJECT - - - - -1
1.2 AIMS AND OBJECTIVE OF THE PROJECT - - - -2
1.3 SCOPE OF THE PROJECT - - - - - - -2
1.4 DEFINITION OF TERMS - - - - - - - 4
1.5 PROJECT REPORT ORGANIZATION - - - - -4

CHAPTER TWO
2.0 LITERATURE REVIEW - - - - - - - -6
2.1 INTRODUCTION - - - - - -- - - -6
2.2 REVIEW OF SENSORS -- - - - - - - -8
2.3 REVIEW OF THE ATMEL AT89S52 MICROCONTROLLER - -10
2.4 REVIEW OF DOOR CONTROL - - - - - -12

CHAPTER THREE
3.0 SYSTEM ANALYSIS - - - - - - - - 14
3.1: INTRODUCTION - - - - - - - - - 14
3.2: THE POWER SUPPLY UNIT: - - - - - - - - 15
3.3: THE CONTROL SECTION: - -- - - - - - 16
3.4: THE SENSOR UNIT: - - - - - - - - - - - - -17
3.5: THE GATE DRIVE UNIT - - - - - - - - - 17
3.6: DESCRIPTION OF COMPONENTS USED IN THE DESIGN - 19
3.6.1: Voltage Regulators - - - - - - - - 19
3.6.2: Transistors - - - - - - - - - 21
3.6.2.1: Types of Transistor - - - - - - - 22
3.6.2.2: Transistor currents - - - - - - - - 23
3.6.3: Light Dependent Resistor (LDR) - - -- - - 26
3.6.4: Electromechanical Relay -- - - - - - - 26
3.6.5: Diodes - -- - - - - - - - - 27
3.6.6: Microcontroller unit: - - - - - - - - 30
3.6.6.1: Features of AT89S52 - - - - - - - 31
3.6.6.2: Pin description - - - - - - - - 34
3.7: SYSTEM SPECIFICATION - - - - - - - 38

CHAPTER FOUR
4.0 CONSTRUCTION APPROACH, CONSTRUCTION STEPS AND
EVALUATION - - - - - - - - - - 40
4.1 CONSTRUCTION APPROACH - - - - - - 40
4.2 CONSTRUCTION - - - -- - - - - 41
4.2.1 COMPONENT TESTING - - - - - - - 42
4.2.2 COMPONENT PLACING - - - - - - - 42
4.2.3 SOLDERING - - - - - - - - - 42
4.2.4 SYSTEM TESTING - - - - - - - - 43
4.2.5 CONSTRUCTION MATERIALS - -- - - - 43
4.3 TESTING EQUIPMENT - - - - - - - - 44
4.4 TESTING METHOD - -- - - - - - - 44
4.4.1 RESISTORS: - - - - - - - - - 44
4.4.2 CAPACITORS: - - - - - -- - - - 44
4.4.3 TRANSISTORS: - - - - - -- - - - 44
4.5 SYSTEM FLOWCHART - - - - - - - - 46
4.6 CIRCUIT DIAGRAM: - - - - - - - - 47
4.6.1 CIRCUIT DIAGRAM EXPLANATION - - - 48
4.7 EVALUATION - - - - - - - - - 48

CHAPTER FIVE
5.0 TEST RESULT, RECOMMENDATION AND CONCLUSION - -52
5.1 SYSTEM TESTING - - - - - - - - 52
5.2 SUMMARY - - - - - - - - - - 52
5.3 RECOMMENDATION - - - -- - - - - 54
5.4 CONCLUSION - -- - - - - - - - 54
REFERENCES - - -- - - - - - - - 56
APPENDIX - - - - - - - - - - 58
CONSTRUCTION OF A MICROCONTROLLER BASED GATE
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0198
  • Access Fee: ₦5,000 ($14)
  • Pages: 58 Pages
  • Format: Microsoft Word
  • Views: 909

500
Leave a comment...

    Related Works

    ABSTRACT The project is based on Construction of microcontroller vehicle speed alarm system which automatically warns the driver by activating a panic alarm which is triggered on when the driver exceeds the speed limit set in the system which also stops the alarm when the speed is reduced... Continue Reading
    ABSTRACT The project is based on Construction of microcontroller vehicle speed alarm system which automatically warns the driver by activating a panic alarm which is triggered on when the driver exceeds the speed limit set in the system which also stops the alarm when the speed is reduced below the set speed limit. A speedometer system is used to... Continue Reading
    ABSTRACT  The project is based on Construction of microcontroller vehicle speed alarm system which automatically warns the driver by activating a panic alarm which is triggered on when the driver exceeds the speed limit set in the system which also stops the alarm when the speed is reduced below the set speed limit. A speedometer system is used... Continue Reading
    BSTRACT Automatic door control is becoming popular due to its numerous benefits. Automatic door control refers to the control of doors and domestic features by just sensing the present of human being at door and automatically open the door with the persons interface or by remote control. Artificial Intelligence provides us the framework to go... Continue Reading
    BSTRACT Automatic door control is becoming popular due to its numerous benefits. Automatic door control refers to the control of doors and domestic features by just sensing the present of human being at door and automatically open the door with the persons interface or by remote control. Artificial I ntelligence provides us the framework to go... Continue Reading
    ABSTRACT This project shows the construction of a microcontroller based security door using smart card. It is aimed towards programming the microcontroller to control the hardware in sliding door. The system consists of a microcontroller 89S52 which sends a signal to the multiplexers on insertion of the smart card in the card slot. The... Continue Reading
    ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the... Continue Reading
    ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a... Continue Reading
    ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a... Continue Reading
    ABSTRACT T-junction traffic light controller is such a device that will play a significant role in controlling traffic at junctions, to ease the expected increased rush at such junctions and reduce to minimum disorderliness that may arise, as well as allowing the pedestrians a right of the way at intervals rather than being struck down when in a... Continue Reading
    Call Us Get this work