Structural Performance Of Lateritic Concrete Containing Palm Kernel Shell (PKS) As A Partial Replacement Of Coarse Aggregate

  • Type: Project
  • Department: Civil Engineering
  • Project ID: CVE0201
  • Access Fee: ₦5,000 ($14)
  • Pages: 75 Pages
  • Format: Microsoft Word
  • Views: 315
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

ABSTRACT

Sand has traditionally been used as fine aggregate in structural concrete. It is usually imported from relatively distant places at high costs, and this increases the overall cost of making concrete and of providing housing in various Nigerian communities. This study investigates the performance of 409/o of laterite as fine aggregate in place of sand, and specifically seeks to determine whether lateritic concrete containing pies would satisfy the minimum compressive strength requirement of BS 8110 (1997) for use in reinforced concrete works, which is 25 N/mm. Ordinary Portland Cement was used as binder. 40%Laterite was used as fine aggregate, while granite was replace by pks which varied from 0% to 50% at intervals of l 0%.The mix design used for the concrete mix is 1:2:4 and the water /cement ratio used is0.5m.The compaction factor test was used to~ the workability of the fresh concrete .The compressive strengths and densities of cured concrete cubes of sizes, 150mmx}50mmxJ50mm were evaluated at 7days, 14days, 2ldays, 28days,60days and 90days curing day in total taking the number of cubes to 126cubes . Increase in the percentage replacement of granite lowered compressive strength and workability. The result shows that control bad 10mm and 0% pks had 6mm.tbis reduction in slump is as a result of the 40% replacement of sand aggregate with laterite aggregate. The mix containing 1 O"/o pks had slump of Omm(zero).This is the result of the replacement of granite aggregate with pks aggregate, which have a high water absorption rate. At 50% content shear slump took place and the test was repeated again, shear slump occurred. It was also observed that the compressive strength of concrete increased rapidly with age until the 28th day after which strength developed or reduced gradually until the 90th day. The control concrete had the greatest compressive strength at all the curing ages ,the compressive strength of concrete at 28 days were in range of 8.71N/mm2 to 24 N/mm2 and those of7 days varied from 4.65 N/mm2 to 15.99 N/mm2• Compressive strength values of the normal weight concrete is about twice that of the palm kernel shell which is normal as PKS is lighter and workability is also reduce. Therefore it can be used to produce lightweight concrete like lintel and roads. 

Structural Performance Of Lateritic Concrete Containing Palm Kernel Shell (PKS) As A Partial Replacement Of Coarse Aggregate
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Civil Engineering
  • Project ID: CVE0201
  • Access Fee: ₦5,000 ($14)
  • Pages: 75 Pages
  • Format: Microsoft Word
  • Views: 315

500
Leave a comment...

    Related Works

    ABSTRACT Sand has traditionally been used as fine aggregate in structural concrete. It is usually imported from relatively distant places at high costs, and this increases the overall cost of making concrete and of providing housing in various Nigerian communities. This study investigates the performance of 409/o of laterite as fine aggregate in... Continue Reading
    TABLE OF CONTENTS DECLARATION..........................................................................................................................ii APPROVAL............................................................................................................................... iii... Continue Reading
    ABSTRACT In an attempt to reduced non-renewable material usage, reduce green-house substances and at the same time be relevant to our environment, this research presents the progress of investigation going on to evaluate some properties of POEBA as partial replacement of cement in the production of structural concrete. This research work is... Continue Reading
    ABSTRACT The Reuse of waste glass in concrete production is among the attractive option of achieving waste reduction and preserving the natural resources from further depletion thereby protecting the environment and achieving sustainability. This present study examined the variation in the strength prope1ties of concrete using waste glass... Continue Reading
    ABSTRACT In an attempt to reduce non-renewable material usage, reduce green-house substances and at the same time be relevant to our environment, this research presents the progress of investigation going on to evaluate some properties of EPO-FBA as partial replacement of cement in the production of structural concrete. This research work is... Continue Reading
    Table of contents Contents                                                                 Page Title page                                                     ... Continue Reading
    ABSTRACT Palm Oil processing yields a considerable quantity of palm kernel shell (PKS) and mesocarp fruit fiber (MFF). This has been predominantly used as fuel through direct combustion which is inefficient and polluting. Better grade fuel could be derived through... Continue Reading
    ABSTRACT Palm Oil processing yield a considerable quantity of palm kernel shell (PKS) and mesocarp fruit fiber (MFF). This has been predominantly used as fuel through direct combustion which is inefficient and polluting. Better grade fuel could be derived through torrefaction. The objectives of the work therefore was to determine the optimum... Continue Reading
    ABSTRACT Palm Oil processing yield a considerable quantity of palm kernel shell (PKS) and mesocarp fruit fiber (MFF). This has been predominantly used as fuel through direct combustion which is inefficient and polluting. Better grade fuel could be derived through torrefaction. The objectives of the work therefore was to determine the optimum... Continue Reading
     This project work aims at formulating Scheffe’s mathematical model which prescribes concrete mix ratios for a desired compressive strength of periwinkle shell aggregate concrete and obtaining the  combination of water, cement,  river sand and periwinkle shell which will produce the optimum strength.The model was formulated from first... Continue Reading
    Call Us Get this work