CONSTRUCTION OF RADIO FREQUENCY GSM SIGNAL JAMMER

  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0456
  • Access Fee: ₦5,000 ($14)
  • Pages: 56 Pages
  • Format: Microsoft Word
  • Views: 201
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853
This project is mainly intended to prevent the usage of mobile phones in places inside it coverage without interfering with communication channels outside it range, thus providing a cheap and reliable method for blocking mobile communication in the required restricted area only. Although we must be aware of the fact that nowadays lot of mobile phones can easily negotiate the jammer effect are available and therefore advance measures should be taken to jam such type of devices. The main disadvantage of the mobile phone jammer is that the transmission of the jamming signal is prohibited by law in many countries. These disadvantages will restrict the use of Radio Frequency jammer. 


The Development of Wireless Signal Jammer for Security Application objective is:
•To design Radio Frequency (RF), Intermediate Frequency (IF), and Power Supply circuit. To construct the Development of Wireless Signal Jammer for Security Application’s circuit. 
•To construct the development of wireless signal jammer for security application’s circuit. 
•To simulate Intermediate Frequency (IF) section circuit. 
•To block mobile phones transmission by creating interference. 
•To block amplitude modulated and frequency modulated signal transmission by creating interference within its range. 


Scope of Project /Limitation 
This project only focuses on blocking the signal transmission of GSM900 which is the range between 935 to 960 MHz. This is because the components are hard to find in Nigeria for the GSM1800 frequency range between 1805 to 1880 MHz The components for GSM1800 are also very expensive compared to GSM900.

The second limitations of the project are, the device only can block the three main operators which are ETISALAT, MTN and GLOBACOM. This is because, the lines are only for Nigerian users and the frequency band range is between 935 to 960 MHz. These requirements fulfil the GSM900 specifications.

The third limitation is that for reliability of the jammer, a Radio Frequency amplifier should be incorporated but the components required for this are difficult to find in Nigeria.
 

Introduction 
A wireless signal jammer is a device which blocks transmission by creating interference. This wireless signal jammer can be categorized into the Radio Frequency (RF) jammer and GSM jammer.

A Radio Frequency jammer is a device used to disrupt or prevent communication via a broadcasted RF signal. It is an RF and GSM frequency disrupter commonly known as wideband radio frequency (RF) and GSM cell phone jammer. Simultaneously, they can blocks all commercial FM broadcast band (87.5 MHz to 108 MHz) and GSM signal transmissions within the jammer's transmission range. The device can possibly block these frequencies by transmitting a dirty signal (like noise) on the same frequency at which the GSM and radio system operates.

A Radio Frequency jammer is a device that transmits a radio frequency signal on the same frequency at which the radio system operates and the jamming succeeds when the radio sets in the area where the jammer is located are disabled.

A GSM jammer is a device that transmits a signal on the same frequency at which the GSM operates. The jamming succeeds when the mobile phones in the area where the jammer is located are disabled.

In recent times, where bombs are being planted and detonated by GSM or Radio Frequency signals, this device can be at an advantage by jamming the signals required for the detonation of the bomb.

Presently, the mobile jammer devices are becoming civilian products rather than electronic warfare devices, since with the increasing number of the mobile phone users the need to disable mobile phones in specific places where the ringing of cell phone would be disruptive has increased. These places include worship places, university lecture rooms, libraries, concert halls, meeting rooms, and other places where silence is appreciated.

The solution to these annoying and disrupting noises is to install a device which can block the signal transmission from mobile phones and radio sets and thus, disrupt the triggering of bombs by these wireless signals.

CONSTRUCTION OF RADIO FREQUENCY GSM SIGNAL JAMMER
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Electrical Engineering
  • Project ID: ELE0456
  • Access Fee: ₦5,000 ($14)
  • Pages: 56 Pages
  • Format: Microsoft Word
  • Views: 201

500
Leave a comment...

    Related Works

    CHAPTER ONE INTRODUCTION A wireless signal jammer is a device that blocks the transmission by createing interference. This wireless signal jammer can be classified as Radio Frequency Interference (RF) and GSM jammer. A radio frequency jammer is a device used to disrupt or prevent communication through a broadcast RF signal. It is a GSM RF... Continue Reading
    Table of Contents APPROVAL..................................................................................................................................................... i ACKNOWLEDGEMENT ................................................................................................................................ ii... Continue Reading
    THE DESIGN AND CONSTRUCTION OF MINI RADIO BROADCAST TRANSMITTERAND AUDIO CONSOLE USING FREQUENCYMODULATION (FM) WITH POWER RATING OF 1 WATT ABSTRACT The early transmitter for radio broadcasting is so big and bulky that they do occupy numerous spaces. The circuitries are mainly designed with valves, which are big in sizes. With the advent of... Continue Reading
    ABSTRACT The aim of this project, the design and implementation of an RF communication link, is to design a communication link between a source and a destination and study the properties of the signal being generated by the source (generator). The area of interest in this work is how the signal suffers limitations like attenuation, interference... Continue Reading
    ABSTRACT The aim of this project, the design and implementation of an RF communication link, is to design a communication link between a source and a destination and study the properties of the signal being generated by the source (generator). The area of interest in this work is how the signal suffers limitations like attenuation, interference... Continue Reading
    ABSTRACT The challenges of the manual method of taking attendance include difficulty in keeping the attendance list over a long period of time, time wasting during writing or signing, students forgetting to sign and students signing illegally for an absentee. This manual process has a lot of problems which may affect the productivity and... Continue Reading
    ABSTRACT This project work deals on the design and implementation of a Rf based wireless batch counting device for brewery capable of counting the bottled products in the conveyor and displaying the value numerically and wirelessly to its receiver installed about 100 meters... Continue Reading
    CHAPTER ONE INTRODUCTION 1.1 Background of Study The accessibility of virtually all material on the World Wide Web nowadays have make students less encouraged to come to lectures than ever before (Hornback et al 2005) and lecturers are worried about student erratic... Continue Reading
    TABLE OF CONTENTS DECLARATION ..................................................................................................................i APPROVAL.........................................................................................................................ii... Continue Reading
    ABSTRACT Accurate meter readings, timely and correct bills have become an important aspect of water metering systems. Additionally, anomalies such as leakage and bursts in water pipelines have significant consequences to the environment and lead to financial constraints to the water companies. Since monitoring leakages and bursts in the water... Continue Reading
    Call Us Get this work