Structural and Optical Properties of ZnO Nano-Powder Synthesized by Combustion and Sol-gel Method

  • Type: Project
  • Department: Physics
  • Project ID: PHY0069
  • Access Fee: ₦5,000 ($14)
  • Pages: 51 Pages
  • Format: Microsoft Word
  • Views: 195
  • Report This work

For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Abstract Nowadays, ZnO is considered as the most important chemical compounds due their distinctive properties owing to its wide band gab and large exciton binding energy. It is well known that the structural and the optical properties of ZnO differ by different methods of preparation. Therefore, in this work, ZnO power was prepared by two methods, namely sol-gel and combustion method with the aim of comparison. The obtained samples from both methods were investigated by many techniques for considerable comparison. The obtained results from ZnO synthesized by the sol- gel method showed that the crystallite size of ZnO was increases by increasing of the annealing temperature. Also little change in the lattice parameter was observed when the annealing temperature increased. It is observed also that similar structure of ZnO prepared by sol-gel and combustion can be obtained at particular conditions. TEM studies showed that the ZnO nanocrystals are irregularly spherical with average diameter of 32 nm, which is similar to the calculated crystallite size from the XRD data. The calculated energy band gab of ZnO prepared by combustion method is found to be 3.2 eV while for samples prepared by sol-gel method is found to be increased with increasing the annealing temperature. There was a clear difference between the two PL spectra obtained from ZnO synthesized by sol-gel and combustion method which is assigned to be due to complicated defect chemistry relevant to the experimental process.

List of Contents

No Topics Page

I اآلية

Dedication Ii

Acknowledgements Error!

Bookmark

not

defined.

Abstract Iv

Abstract (Arabic) Error!

Bookmark

not

defined.

Keywords and acronyms Vi

Table of Contents Vii

List of figures Xi

List of tables Xi

No Chapter One (Introduction)

1.1 Overview 1

1.2 Literature review 3

1.3 Problem statement 4

1.4 Research Objectives 4

1.4.1 General Objective 4

1.4.2 Specific Objectives 5

1.5 Dissertation layout 5

Chapter Two (Theoretical background)

2.1 Overview 6

2.2 Structural properties 6

2.2.1 Scherrer's equation 10

2.2.2 Lattice parameters 10

2.3 Optical properties of ZnO 11

2.3.1 Determination of Energy gabs from reflectance spectra 11

2.4 Mechanical properties of ZnO 12

2.5 Electrical properties 13

2.6 Native type of Defects in ZnO 13

viii

2.7 Applications of ZnO 14

Chapter Three (Experimental and Characterization techniques)

3.1 Experimental 15

3.1.1 Sol-gel method 15

3.1.2 Combustion method 16

3.2 Characterization techniques 17

3.2.1 X-ray Diffraction (XRD) 17

3.2.1.1 Bragg's law 18

3.2.2 Transmission Electron Microscopy (TEM) 19

3.2.3 Ultraviolet Visible Spectroscopy (UV-Vis) 21

3.2.4 Photoluminescence spectroscopy (PL) 23

Chapter Four (Result and Discussion)

4.1 Structure properties 25

4.1.1 X-rays diffraction studies 25

4.1.2 TEM studies 28

4.2 Optical studies 30

4.2.1 UV-Vis studies 30

4.2.2 Photoluminescence studies 33

Chapter Five(Conclusion and future works)

5.1 Conclusion 36

5.2 Future works 37

5.3 References 38



Structural and Optical Properties of ZnO Nano-Powder Synthesized by Combustion and Sol-gel Method
For more Info, call us on
+234 8130 686 500
or
+234 8093 423 853

Share This
  • Type: Project
  • Department: Physics
  • Project ID: PHY0069
  • Access Fee: ₦5,000 ($14)
  • Pages: 51 Pages
  • Format: Microsoft Word
  • Views: 195

500
Leave a comment...

    Related Works

    Abstract Nowadays, ZnO is considered as the most important chemical compounds due their distinctive properties owing to its wide band gab and large exciton binding energy. It is well known that the structural and the optical properties of ZnO differ by different methods of preparation. Therefore, in this work, ZnO power was prepared by two... Continue Reading
    OPTICAL AND STRUCTURAL PROPERTIES OF COPPER ALUMINUM DISELENIDE (CuAlSe 2 ) COMPOUND THIN FILMS ABSTRACT A low cost chemical bath deposition technique has been used for the preparation of Copper aluminum diselenide (CuAlSe2) thin films onto commercial microscope glass substrates. The values of deposition parameters were varied such as... Continue Reading
    ABSTRACT This work investigates the optical properties of glass prepared using Otamiri Silica sand mixed with analytical grade oxides as a function of their composition. Three batches were prepared with Phosphorus as the main variable of the SiO2-Na2OB2O3-CaO-ZnO glass system. The glass was melted in a ceramic crucible with a lid and the glasses... Continue Reading
    The household lighting cost accounts for 10% of the electric bill, changing the light bulbs effectively can reduce the long term energy costs significantly. In Nigeria, where less than one percent of the population has access to 24 hours of interrupted power supply there is a need for a complementary, renewable source of light which provides... Continue Reading
    The household lighting cost accounts for 10% of the electric bill, changing the light bulbs effectively can reduce the long term energy costs significantly. In Nigeria, where less than one percent of the population has access to 24 hours of interrupted power supply there is a need for a complementary, renewable source of light which provides... Continue Reading
    ABSTRACT           The project titled “The effect of admixtures on properties of concrete: case study of sugar, cow bone ash, groundnut shell ash, and lime stone powder” was carried out with the aim of knowing the effect the of the various types of admixtures used on the properties of concrete, in term of the workability of concrete,... Continue Reading
    ABSTRACT The effects of variety and processing methods on the functional properties of cassava flours were studied. The functional properties of the flour were determined using standard procedures. Cassava roots were fermented, blanched, soaked, dried and milled into flour. The functional properties of the flour were determined. There were variety... Continue Reading
    ABSTRACT The effects of variety and processing methods on the functional properties of cassava flours were studied. The functional properties of the flour were determined using standard procedures. Cassava roots were fermented, blanched, soaked, dried and milled into flour. The functional properties of the flour were determined. There were variety... Continue Reading
    ABSTRACT In an attempt to reduced non-renewable material usage, reduce green-house substances and at the same time be relevant to our environment, this research presents the progress of investigation going on to evaluate some properties of POEBA as partial replacement of cement in the production of structural concrete. This research work is... Continue Reading
    Abstract: Thin films of Copper Nickel Selenide (CuNiSe) were synthesized on glass slides at room temperature using chemical bath deposition (CBD) method. The films were deposited from aqueous solution containing copper ion, nickel ion and potassium selenate (K2SeO4) at varying molar concentration of nickel ion with constant time and pH of the... Continue Reading
    Call Us Get this work